DIY Project || #6 || Jewelry Wall Branch

INGREDIENTS:

Stray branch (don't harm the trees!)

Long, thin leaves or yarn

Thin hair ties

White push pins

INSTRUCTIONS:

STEP ONE: Carefully loop a long branch leaf (or yarn!) around the furthest stable ends of the branch.

STEP TWO: Grab the leaf edges together and slowly begin tying the thin hair tie as though it were a ponytail. Leave a little slack which will be used later to slip over the pushpin in the wall.

STEP THREE: The branch should look like this -- kind of like a large tear drop.

STEP FOUR: Then, press two push pins into the wall. It helps to put the branch up against the desired wall area and lightly mark the width of the branch with a pencil. I ended up placing the pins a few inches inside of the very edges.

STEP FIVE: Taking the little slack in the hair tie, loop it over the pushpins on the wall. 

STEP SIX: If necessary, readjust the pins of your wall to level out the branch so it is as straight as possible. Then, just begin draping your necklaces, hook your earrings, and hang your bracelets!